Terms and Definitions


Chip Installation TD-100 Point to Point

TD-100 Handpiece
TD-100 Handpiece
Chip Components
Chip Components

1. Set a tip temperature of 343°C (650°F) for lead-free or 316°C (600°F) for leaded alloys and adjust as necessary.

2. Install chisel or conical tip into TD-100 using Tip Tool.

3. Position component ensuring proper lead-to-land alignment. Hold component in place using the tweezers. (A)

4. Apply flux and tack solder one side. (B)

5. Apply flux to both sides to be soldered.  (C)

6. Clean tip using Tip & Tool Stand sponge. (D)

7. Position chisel tip on lead/land area. Apply solder to side of lead/land areas to form proper solder fillet. (E)

8. Re-tin tip with solder. Return TD-100 to its Tip & Tool Stand.

9. Clean if required, and inspect.

PACE Intelliheat® Power Supply
TD-100 Thermo-Drive® Soldering Iron
Chisel or Conical Tip (See Chart on Back)
Tip Tool
Flux-cored Solder